OREO Plastic Charm オレオのプラバンチャームを作ってみた | MosoGourmet 妄想グルメ

We made a OREO charm using almost entirely material from the 100 yen shop! We're not great at drawing so we colored into decals. You can enjoy creating cheap DIY's thanks to 100 yen shops like Cando or Daiso. We live in blessed times!
We received a comment that said that MosoGourmet seem to only make food crafts, but recently we've been getting the itch to get into things such as sewing and other handicrafts!
*Recipe*
1. Cut the plastic molds from Cando into 5cm squares, write the direction of the plate, and do a test bake. It is convenient to know the characteristics of the board because it shrinks and warps differently depending on them.
2. Mark it with masking tape so that you can see the vertical and horizontal directions and the front and back of the mold.
3. Cut the mold. If you want to make several, make the design face the same direction. The mold should be neatly shrunk by now.
4. File the entire surface so that the back of the mold is curved, with a #400 file from Daiso.
5. When the entire unit becomes white, remove any debris with a wet tissue.
6. When the plastic base has dried, use a pencil to trace onto pattern paper the face that was filed down.
7. Color in with color pencils. This time, we used a watercolor pen. Watercolor pencils are sold in 12 colors at Cando and Daiso.
8. In the case of a watercolor pen, blur the color with a brush (from Daiso) containing a small amount of water (Daiso also sells paint plates). It ’s okay as it is.
9. Cut a little inside the frame with scissors or a cutter.
10. Bake in a preheated toaster oven for about 2 minutes. Put it on the oven sheet (colored side up) and keep it in the oven toaster, keeping an eye on it while it shrinks. When it stops shrinking, take a breath and take it out the oven sheet.
11. Place it on a hard, flat surface that is resistant to heat and press it with a metal tray. Be careful, it's hot!
12.Make the shrink plastic colored OREO cookie and vanilla cream in the same way. We made a vanilla cream-colored one a little smaller.
13. When it cools down, apply your favorite top coat. This time, we used a water-based topcoat spray (a matte "Mr.hobby"). When it dries up, spray it on the back side (the colored side) to prevent discoloration.
14. Attach your favorite accessories. This time, we drilled holes in it with a hand drill (from Cando) and a pin vice, and attached a crab that I bought at Daiso. Round-nosed pliers and finger holders can be purchased at a 100 yen shop.
15. All done. We'd like to make it again!

大好きなオレオのキーホルダーを作りました。まだまだ修行が足りませんが、ほぼ100均アイテムで作れるプラバン工作、楽しいです。(クッキングシート使用上の注意 https://www.lion.co.jp/ja/products/246 )

*レシピ*
1.プラバン(キャンドゥ)は5センチ四方に切り、板の方向を書き込んで試し焼きをする。板によって縦横の縮み方、反り方が異なるので、その板の性格を知っておくと便利です。
2.プラバンの縦横の方向と表裏が、わかるようにマスキングテープなどで印を付ける。
3.プラバンを切る。いくつか作る場合はデザインの縦横を同じ方向にする。プラバンの縮み方が揃ってきれいに仕上がる。
4.プラバンの表裏を400番のヤスリ(ダイソー)でくるくると全面ヤスル。
5.全体が白くなったらウエットティッシュなどでゴミを落とす。
6.プラバンが乾いたら、裏面にオレオの形を写す。
7.色鉛筆で着色する。今回、水彩色鉛筆を使いました。水彩色鉛筆はキャンドゥとダイソーで12色入りが売られていました。
8.水彩色鉛筆の場合は、少量の水(絵具皿はダイソー)を含ませた筆(ダイソー)で色をぼやかしてもよい。濃くしたいときは乾かないうちに水彩色鉛筆で書き足す。そのままでも大丈夫です。
9.ハサミやカッターを使って枠のほんの少し内側を切る。
10.2分ほど予熱したオーブントースターで焼く。オーブンシートにのせ、オーブントースターに入れると数秒で縮んでくるので目を離さないこと。縮むのが止まったら一呼吸おいてオーブンシートごと取り出す。(クッキングシート使用上の注意 https://www.lion.co.jp/ja/products/246 )
11.熱に強い、固く平らな物の上に置き、金属のバットなどでプレスする。熱いので気をつけて!
12.オレオクッキー色とバニラクリーム色に着色したプラバンも同様に作る。バニラクリーム色のプラバンは一周り小さく作りました。
13.冷めたらお好みのトップコートをする。今回は水性トップコートスプレー(GSIの つや消し)をしました。乾いたら裏面(色鉛筆面)にもスプレーし色落ちを防ぐ。
14.好みのアクセサリーパーツを付ける。今回はハンドドリル(キャンドゥ)やピンバイスで穴を空け、ダイソーで買ったカニカンを付けました。ラジオペンチや指かん(ダイソー)も100円ショップで買うことができます。
14.でけた。次はもっと頑張りたい。

#oreo ##DIY #Charms #ShrinkPlastic #craft #手作り #プラバン #工作 #オレオ
Share this Post:

Related Posts: